Digital Equipment DIGITAL Server 7100 1200, Service Maintenance Manual, Page: 25 / 162

Server Software and Utilities
2-4
Starting the SCU
The SCU is located on the ServerWORKS Quick Launch CD-ROM disk. The SCU
options are shown in Figure 2-1. If this is your first time using the SCU, it is
recommended that you select “Learn About Configuring your Computer” for detailed
information on using the SCU. If this is a subsequent session, refer to the
appropriate sections in this chapter to change the server’s configuration.
You can start the SCU in one of three ways:
1. During the Quick Launch boot process, if a DOS partition was created, the
SCU was copied to the partition on the hard disk drive. This allows you to
run the SCU anytime from the DOS partition.
At the MS-DOS prompt change to the SCU directory and type:
SCU.BAT
2. Creating a bootable SCU diskette by using the Quick Launch CD-ROM and
selecting the
Installations & Utilities button and then the Utilities page. On
the Utilities page, select the appropriate BIOS level for the server that the
SCU is being created for (if this is being done on the server, the default
BIOS that is highlighted is the BIOS of that server)
.
Afterwards, you can run the SCU anytime by booting the diskette you
created.
3. You can also run the SCU by inserting the Quick Launch CD-ROM disk,
rebooting the server, and pressing and holding the right [ALT] key during the
boot process to display the SCU.
NOTE:
If EISA (in some cases, PCI) cards have been added to
the server, the SCU will be invoked automatically when you boot
from the Quick Launch CD-ROM disc. The .SCI file is not saved
when you use this method to run the SCU.