Digital Equipment DECagent 90, User Information

Page: 67 / 92

Use the ’Move Module’ command to vacate the desired slot.
This message appears after you choose the Add Module option, when you have
attempted to add an agent or bridge to an inappropriate slot, but one of the
appropriate slots could be made available by using the Move Module option.
You may enter 1 more trap address for this community.
You may enter up to ’nn’ more trap addresses for this community.
One of these messages appears after you choose the Add Community Trap
Addresses option, to inform you of the number of available trap table entries.
You must use the Move Module command to move the ’module type’ to an
appropriate slot.
This message appears after you choose the Change Community Size/Type option
when you have been prompted to move an agent or a bridge to another slot and
you have pressed Ctrl/C or ESC to abort the move. You should move the module
to an appropriate slot before attempting to change the community size.
Error Messages
The following section lists the error messages that might appear at the console.
A module was found in slot ’nn’.
’nn’ modules were found in slots ’xx’ through ’yy’.
One of these messages accompanies the "Unable to change community size"
message issued when you choose the Change Community Size/Type option, to
indicate the reason why the agent was unable to change the community size.
A ’module type’ in slot ’xx’ of community [’nn’] has MAC address xx-xx-
xx-xx-xx-xx
This message appears when you attempt to add a module to a community and the
specified MAC address is discovered in another module elsewhere in the agent’s
database. You should check the other module to be sure that the MAC address is
correct. Duplicate MAC addresses are not allowed.
A trap address cannot be the DECagent 90’s IP address.
This message appears when you attempt to add a trap address to a community
that is the same as the agent’s IP address. You cannot specify that traps
generated by the agent be sent to the agent.
Console Messages B–5