Installing and Removing Components
AlphaServer 1000 Rackmount Owner's Guide 5-17
Removing Externally Accessible Devices
To remove a tape drive, reverse the order of steps 3 through 7 in the installation
procedure.
Installing a Diskette Drive
To replace a 31/2-inch diskette drive, refer to Figure 5-14 and perform these
steps:
1.
Remove the original diskette drive.
2.
Locate the ID select switch toward the rear on the righthand side of the
replacement diskette drive. Set the switch to the 1 position.
3.
Slide the diskette assembly into the front of the bay until the screw holes align with
the holes on the bracket.
4.
Attach the mounting bracket to the replacement diskette drive using the two screws
you removed from the original diskette drive.
5.
Connect the power cable and the data cable to the diskette drive.
Figure 5–14: Replacing or Installing a Diskette Drive
MLO-011581
2
3
1
1 Screws (2)
2 Data cable
3 Power cable
