DigiOpG2 Digital Video Recorder for 4-8-16 cameras Page
35
3040-00057
Network
Select “Enable network” to transmit images via Internet.
Network Setup
Click the [Edit] button and the Network setting screen will appear. Input
required information as requested.
Network Adapter
Select the present network card attached.
IP Address
Input the IP address used in network setting. Select “Obtain an IP
address automatically” and it will be automatically allocated in the OS.
When the OP address is automatically allocated in the OS, the
DigiOpG2G2 cannot be connected to the NetAgent.
Select “Specify an IP address” and an IP address will be selected
automatically. Click the keyboard, which is beside the box to input the
OP address. Then, input the address in the virtual keyboard that
appears.
Gateway
Input gateway address when it is needed.
DNS
Input DNS setting when it is needed.
Connection Time Limit
Select “Connection Time Limit” to limit the connection time with Agent
Series. The time limit can be set up to maximum of 120 minutes. For
example, to connect and transmit images through Agent Series for only
30 minutes, select “Connection Time Limit” and set 30 minutes. When
30 minutes have been passed, the Agent automatically disables
connection.
Disconnect when there is no transmission
To stop the transmission within the pre-selected time limit when there is
no response due to transmission errors, select “Auto Disconnect on no
activity after” and select the desired time limit. The maximum time limit
can be set up to 20 minutes.
Remote Overlay Control (Supported only in NetAgent)
Control the live images in NetAgent remote controller. This category cannot
be used since EDNS-4000 does not support the real-time video.
Allow Time Synchronization (Supported only in NetAgent)
The NetAgent remote controller sets the time of the DigiOpG2G2 to be
same with it. The DigiOpG2G2 can use the remote notification category
to set the time in the NetAgent. So, the NetAgent must be registered in
the remote notification category to have the same time with the
DigiOpG2G2. The NetAgent transmits the time of the NetAgent to the
DigiOpG2G2 in intervals.
When Allow Time Synchronization is selected,
DigiOpG2G2 takes into account of the time difference with NetAgent,
synchronizing the time of NetAgent and DigiOpG2G2 to the designated
TimeServer in every hour.
