DigiOpG2 Digital Video Recorder for 4-8-16 cameras Page
34
3040-00057
All Ranges
When all ranges is selected, any motion detected in the entire screen is
recorded. The all ranges are set as default. Selecting “Cover Entire
Area” and motion sensor detector allows to record only when motion is
detected. Setting as continuous mode, all the images will be recorded in
the entire area. Be cautious when selecting the continuous mode
because the saving capacity becomes large. The default is “Cover Entire
Area.”
When “Cover Entire Area” is not checked the message as the left
window appears, and the red border is drawn.
Image Quality
Use the slide bar to control the setting value for clearer recording image.
When setting the image quality different for each channel, select the
camera number then set the image quality.
Movement Sensitivity
Motion sensitivity of the images can be adjusted by using the slide
selection bar. We recommend users to record smaller movements with
higher sensitivity level. (Default: 80)
Motion Detection
DigiOpG2G2 is set up as motion detection saving state.
By clicking the Motion Detection button (
), it continuously records.
10.2.
Network
In this section, the selections for the Internet, user ID and other options are selected to transmit images using Agent Series remote distance
surveillance system.
Bandwidth Limit
It is possible to limit the bandwidth used on the LAN NETWORK transmitting video to a PC with an Ernitec Agent software. The bandwidth
limiter can be found under the Network tab in Configuration, located on the bottom left. Adjustments can be made in the Mbps (from 0 –
100) or Kbps (from 0 – 990). Note that 0 is unlimited.