DigiOpG2 Digital Video Recorder for 4-8-16 cameras Page
21
3040-00057
5.
Connecting the EDNS5/6000 Digital Video Recorder.
This section describes how to connect the DigiOpG2 DVR to peripheral devices. Be sure to turn off the power
before making any connections.
Camera
Be sure to match the type of cameras to the corresponding system. To get the better image, use 75 ohms
coaxial cable and make connections firmly.
Note: Use the DigiOpG2 controller to operate the Camera’s location, zoom or focus point with the
operation of other parts like the siren, alarm and etc. Refer to the detail explanations later in this manual.
Monitor
Basically, the DigiOpG2 DVR provide dual display mode. The camera images can be seen in on a normal
CCTV monitor or on a PC monitor. The PC monitor must have a resolution of 800x600 and frequency of
60Hz or more.
Sensor input and control output
.
The connector for alarm sensors placed on the rear panel of the DigiOpG2G2 allows connection of up to
16 external sensors and have 8 control outputs (relays). The sensor input accept either N/O or N/C relay
contact. Any sensor input can trigger one of the 8 alarm outputs. These outputs are used to control
external equipment, such as Light, Siren, etc.
Printer
To print out the images searched by the DigiOpG2 Viewer, you need to install the corresponding printer
drive before using the printer. Refer to the section “adding printer” later in the operation manual.
Network
Connect the DigiOpG2 DVR to the network (LAN, WAN etc.) and transmit images to the DigiOpG2
NetAgent software Series. Please contact your dealer or network supervisor if you need any assistance.
