Routing
Virtual Router Redundancy Protocol (VRRP)
IX20 User Guide
260
Task 2: Configure VRRP+ on device two
1. Enable VRRP+:
(config network vrrp VRRP_test)> vrrp_plus enable true
(config network vrrp VRRP_test )>
2. Add the interface to monitor:
(config network vrrp VRRP_test)> add vrrp_plus monitor_interface end
/network/interface/modem
(config network vrrp VRRP_test)>
3. Enable the ability to monitor the master device:
(config network vrrp VRRP_test)> vrrp_plus monitor_master true
(config network vrrp VRRP_test)>
4. Set the amount that the device's priority should be decreased or increased due to SureLink
connectivity failure or success to
30
:
(config network vrrp VRRP_test )> network vrrp VRRP_test vrrp_plus weight
30
(config network vrrp VRRP_test )>
Task 3: Configure the IP address for the VRRP interface, ETH2, on device two
1. Type
...
to return to the root of the config prompt:
(config network vrrp VRRP_test )> ...
(config)>
2. Set the IP address for ETH2:
(config)> network interface eth2 ipv4 address 192.168.3.2
(config)>
3. Set the default gateway to the IP address of the VRRP interface on the master device,
configured above in
(
192.168.3.1
).
(config)> network interface eth2 ipv4 gateway 192.168.3.1
(config)>
Task 4: Configure SureLink for ETH2 on device two
1. Enable SureLink on the ETH2 interface:
(config)> network interface eth2 ipv4 surelink enable true
(config)>