Services
Configure the ping responder service
IX10 User Guide
519
n
To limit access to specified IPv4 addresses and networks:
(config)> add service iperf acl address end
value
(config)>
Where
value
can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any
: No limit to IPv4 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service iperf acl address6 end
value
(config)>
Where
value
can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any
: No limit to IPv6 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX10 device:
(config)> add service iperf acl interface end
value
(config)>
Where
value
is an interface defined on your device.
Display a list of available interfaces:
Use
... network interface ?
to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
Default IP
defaultlinklocal
Default Link-local IP
eth
ETH
loopback
Loopback
modem
Modem
config)>
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service iperf acl zone end
value
