Services
Location information
IX10 User Guide
452
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source )>
The location source is enabled by default. To disable:
(config service location source )> enable false
(config service location source )>
4. (Optional) Set a label for this location source:
(config service location source )> label "label"
(config)>
5. Set the
type
of location source to
user_defined
:
(config service location source )> type user_defined
(config service location source )>
6. Set the latitude of the device:
(config service location source
coordinates latitude
int
(config service location source )>
where
int
is any integer between
-90
and
90
, with up to six decimal places.
7. Set the longitude of the device:
(config service location source
coordinates longitude
int
(config service location source )>
where
int
is any integer between
-180
and
180
, with up to six decimal places.
8. Set the altitude of the device:
(config service location source
coordinates altitude
alt
(config service location source )>
Where
alt
is an integer followed by
m
or
km
, for example,
100m
or
1km
.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
