OPERATOR’S MANUAL
ISO
6
Version 4 Quick Start Guide
FRAME FOLD/WORKING HYDRAULICS / 51
6011662 Rev B
FRAME FOLD/WORKING
HYDRAULICS
Frame Fold/Working Hydraulics can be enabled in the ISO
6
Master Module by unlocking the specific feature key in the ISO
6
master module. It will also require an FCOM (Frame Control
Output Module) and harnessing to properly function.
Frame Fold/Working Hydraulics, or a FPOM (Frame Power
Output Module), are designed to provide output/input connection
to sensors and solenoid valves to open/close hydraulic circuit
paths to be able to utilize hydraulic remotes on tractors to
perform multiple functions. Example would be using 1 hydraulic
remote to control planter markers and planter fold cylinders by
diverting oil flow paths with a FCOM output function and proper
solenoid valve.
FAME FOLD/WORKING HYDRAULICS
Frame Fold
–
Frame Fold function outputs are only accessible
by navigating out of the main work screen and into the Fold
Sequence menu.
Working Hydraulics
–
Working Hydraulic function outputs are
accessible from the Work Screen or from the Fold Sequence
menu. It is not recommended to put any undesired outputs as a
Working Hydraulic function unless you want to control the output
while operating the implement.
SETTING UP FRAME FOLD CONTROLS:
1. Navigate to the Frame Fold Setup by pressing the
FOLD
SEQUENCE
Icon.
2. Press the
NAME ASSIGN
softkey to enter names and
descriptions.
3. Enter the desired name and description for the sequence.
4. Once complete navigate back 1 page and press the
FUNCTION SETUP
softkey.
5. Once in the Function setup menu tap the Func: dropdown
menu and select the FOLD output you would like to set up
(See Figure 39).
-
Once the desired function is selected choose from the
FCOM module address you would like to assign that
output to. To confirm module address; check the
modules screen and verify serial number, address, and
physical position on implement.
-
Next select the output number you would like to control.
