Dibo SBH-E, Manual

Page: 127 / 186

SBH-E : REV A DiBO n.v. 127
7. Malfunction table
At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we
advise to contact a DiBO technician and/or a recognized DiBO representative.
Malfunction Cause Solution
Machine does not start Electrical supply not connected Connect the electrical supply
Net fuse defect Check net fuse
Main switch on “0” Put main switch on “1”
Rest malfunctions Consult an expert
No water pressure To few water inlet Repair water inlet
Filter stuffed-up
&OHDQUHSODFH¿OWHUFDUWULGJH
Instable and to weak pressure Air in water supply (leaks in water
supply) Put machine completely without
power! Repair leaks in supply.
Nozzle or lance stuffed-up or worn-
out. Clean or replace
Pressure regulator defect Consult an expert
Rest malfunctions Consult an expert
Water in product tank
1RQUHWXUQYDOYHLQ¿OWHUGHIHFW 5HSODFHVXFWLRQ¿OWHU
No additions of products Suction pipe Repair suction pipe
6XFWLRQ¿OWHUVWXIIHGXS &OHDQVXFWLRQ¿OWHU
Product tank empty
5H¿OORUUHSODFHWDQN
Spray pressure to high Lower spray pressure
No hot water Main switch not on position “2” Put main switch on position “2”
Heat resistors defective Consult an expert
Temperature sensor defective Consult an expert
Rest malfunctions Consult an expert
HP pump pulse Leak or congestion in supply conduit Clean/replace/repair
To much air present De-aeration of cleaner