Diamond Aircraft DV 20 E 2022, Airplane Maintenance Manual

Page: 577 / 903

AIRCRAFT
DV 20 E AMM Lights
Doc # 4.02.25
Rev. 2
33-40-00
Page 201
15 Mar 2022
Maintenance Practices
1. General
The following maintenance practices describe how to:
)
Remove and install the light units.
)
Adjust the landing light and the taxi light.
)
Remove/install components in the system.
Refer to Chapter 92 for details of the electrical wiring.
WARNING: DO NOT OPERATE THE ANTI-COLLISION LIGHTS WHEN PERSONS
ARE CLOSE TO THE AIRPLANE AND DO NOT LOOK DIRECTLY AT
THE LIGHT WHEN IT OPERATES. ANTI-COLLISION LIGHTS CAN
CAUSE EYE DAMAGE.
2. Remove/Install the Taxi Light
A. Remove the Taxi Light
Detail Steps/Work Items Key Items/References
(1) Set the ELECTRIC MASTER switch to OFF.
(2) Open the TAXI/MAP/ACL circuit breaker
(3) Remove the taxi/landing light cover from the
wing.
S
Examine the white vinyl tape on the cover for
damage. If necessary, replace the tape.
(4) Loosen the lock nuts and remove the screws
that attach the taxi light to the wing.
The taxi light is the outboard assembly.
Refer to Figure 2.
(5) Hold the taxi light and carefully move the light
out from the wing.
S
Disconnect the electrical connector from the
rear of the taxi light.
S
Remove the taxi light.