Diamond Aircraft DV 20 E 2022, Airplane Maintenance Manual

Page: 300 / 903

AIRCRAFT
Equipment/Furnishings
DV 20 E AMM
Page 206
15 Mar 2022
25-10-00
Doc # 4.02.25
Rev. 2
5. Remove/Install the Baggage Compartment Floor Panel
Refer to Figure 3.
A. Remove the Baggage Compartment Floor Panel
Detail Steps/Work Items Key Items/References
(1) Remove inertia reel covers, if fitted.
(2) Remove the screws around the aft edge of the
center floor panel.
(3) Remove the screws along the joints for the left
and right panels.
(4) Remove the fuel dip-stick from the clips.
(5) Remove the screws along the front edge of the
center panel.
Note the location of the baggage net
and the gripper clips for the dip-stick.
(6) Lift the center panel clear.
(7) If necessary, remove the screws from the outer
edges of the outer panels.
Only remove the outer panels, if
necessary.
(8) Lift the outer panel clear.
B. Install the Baggage Compartment Floor Panel
Detail Steps/Work Items Key Items/References
(1) Make sure that there are no unwanted items
below the floor panel.
(2) If necessary, put the outer floor panels in
position.
(3) Install the screws around the edge of the outer
panels.
(4) Put the center floor panel in position.
(5) Loosely install the screws along the forward
edge of the panel.
Each screw attaches the baggage net.
Two screws also attach the clips for the
dip-stick.
(6) Loosely install the screws along the joints of the
left and right panels and the center panel.