Diamond Aircraft DV 20 E 2022, Airplane Maintenance Manual

Page: 385 / 903

AIRCRAFT
DV 20 E AMM Flight Controls
Detail Steps/Work Items Key Items/References
Doc # 4.02.25
Rev. 2
27-31-00
Page 203
15 Mar 2022
WARNING: WHEN YOU DO WORK ON THE AIRPLANE CONTROLS, MAKE
SURE THAT THE AREA AROUND THE CONTROLS/CONTROL
SURFACES ARE CLEAR OF PERSONNEL/EQUIPMENT. IF YOU DO
NOT DO THIS, INJURY TO PERSONNEL AND DAMAGE TO
CONTROL SURFACES CAN OCCUR.
(5) Install the bottom of the elevator vertical control
rod to the elevator bellcrank.
S
Make sure you correctly align the fork
assembly with the spring mount assembly.
S
Install the nut bolt and two washers.
Refer to Figure 1.
Torque to 6.5 Nm (4.6 lbf-ft).
(6) Connect the airplane battery. Refer to Section 24-31.
(7) Do an operational check of the elevator trim
control system.
(8) Do a test for correct, full and free movement of
the elevator control system.
Refer to Section 27-30.
(9) Install the rudder. Refer to Section 55-40.
C. Adjust the Elevator Trim Position Indicator
Detail Steps/Work Items Key Items/References
(1) Remove the instrument panel cover. Refer to Section 25-10.
(2) Remove the rudder. Refer to Section 55-40.
WARNING: WHEN YOU DO WORK ON THE AIRPLANE CONTROLS, MAKE
SURE THAT THE AREA AROUND THE CONTROLS/CONTROL
SURFACES ARE CLEAR OF PERSONNEL/EQUIPMENT. IF YOU DO
NOT DO THIS, INJURY TO PERSONNEL AND DAMAGE TO
CONTROL SURFACES CAN OCCUR.
(3) Using the elevator trim switch set the trim to full
nose up.