Dhollandia DH-L 3300 lbs, Installation Manual, Page: 55 / 82

54
DHOLLANDIA
•
Bleed the air from the hydraulic circuits. Preferably, raise the rear end of vehicle off the ground, or raise its air suspension to the
allowed maximum.
•
Starting from the platform in closed position:
1. OPEN the platform fully to the lowest point and press OPEN for extra 20 sec. CLOSE the platform again and repeat until no
more air bubbles back to the oil reservoir.
2. LOWER the platform fully to the lowest point and press LOWER for extra 20 sec. LIFT the platform again and repeat until no
more air bubbles back to the oil reservoir.
13 LUBRICATION INSTRUCTIONS
•
All articulation points equipped with grease nipples should be lubricated with acid free grease after installation, and once in service
with intervals as indicated in the MAINTENANCE AND REPAIR MANUAL.
•
Refer to appendix 16.4 from page 66 onwards for relevant grease plan of the liftgate, or download any from the
website:
www.dhollandia.com → Country & language selection → Downloads → Maintenance & Repair →
Grease plans → … select required plan
•
Use the grease gun to inject grease, until a grease collar is formed on both
sides of the articulation, that will protect it from ingress of water, salt, sand and
dirt etc.
•
Note that some grease nipples might be less visible, located in the pin itself, or
in the larger assembly that pivots around the pin.
•
In case a pin has 2 grease nipples, grease both sides.
•
Ensure all grease nipples work correctly. Replace any defective nipples.
•
Always acid-free grease. The use of graphite grease is not allowed.
NOTICE
To give the liftgate a good start and maximize its longevity, it is important to
grease all pivot points thoroughly after installation.
EXAMPLE