Dhollandia DH-L 3300 lbs, Installation Manual, Page: 21 / 82

20
DHOLLANDIA
•
Make sure that the holes of the 2 fitting jigs are perfectly aligned. To verify this, slide a round bar through the holes, and check the
alignment with the rear cross member of the vehicle floor.
•
If liftgate is mounted with a seal kit between the closed platform and vehicle body, the position of the fitting jigs must be adjusted to
suit the thickness of the sealing rubbers. See 7.3 on page 21.
7.2 METHOD WITH VERTICAL PLATFORM
•
Attach 2 temporary supports on the rear cross member, at max. 7 3/4” ( 200 mm) from the outside of the body. Make sure these
supports are sufficiently strong to carry the proper weight of the platform during installation.
•
Mount the supports at height pduf below the vehicle floor.
pduf is confirmed on the INSTALLATION
DRAWING and in the POCKET GUIDE.
•
Next, raise the platform and position it onto the supports.
•
Slide a spacer D = ¼” ( 5mm) (see above) between the platform and the rear
frame of the body.
•
Adjust and center its position. Ensure the platform stands perfectly aligned to the
rear frame of the body.
•
Fasten and secure the final position of the platform by means of hoists, clamps,
etc. in order to prevent mounting errors, accidental fall and injuries.
•
If the liftgate is mounted with a seal kit between the closed platform and vehicle
body, the position of the platform must be adjusted to suit the thickness of the
sealing rubbers. See 7.3 on page 21.
WARNING
•
The platform is very heavy! When falling on a person it can cause serious personal injury or death.
•
Therefore, handle the platform with extreme care. Use adequate lifting aids such as a forklift with slings, a gantry crane, hoists
etc. to secure the platform and prevent it from falling.