4.4
Turning the Unit On
To turn the unit on, press and hold the red ‘ON-OFF’ key
for 2 seconds (Fig. 11).
The
‘Status’ LED
will flash slowly green to
indicate that the unit is in ‘STANDBY’ mode.
The first time the unit is powered-on (or after a ‘System Reset’ see Section 6.2), you
will be prompted to select the Testifire operating language for your region. Use the
‘UP’ and ‘DOWN’ keys to navigate and ‘ENTER’ key to select your required
operating language (Fig. 12).
This will display a confirmation screen (Fig. 13). Press the ‘MENU’
key to select or the ‘STATUS’ key to cancel. Once the language
has been selected the ‘MAIN’ menu will be displayed.
The chosen language can be changed at any time by pressing the
‘MENU’ key. Use the ‘UP’ and ‘DOWN’ keys to navigate the
menu and use the ‘ENTER’ key to select ‘Language’ (Fig. 14).
Pressing the ‘ESCAPE’ key goes back to the ‘STANDBY’ screen.
After long periods of non-use or when a Smoke Capsule has been
replaced, the unit will self-prime at power-on, prior to
displaying
the ‘MAIN’ menu. Testifire will show the ‘Preparing for use Please
wait’ message for a short period while it is priming the circuits
ready for use (Fig. 15).
If the unit is left in Standby mode for more than 5 minutes, it will power off to conserve the battery.
Fig. 9
page 10
Spring Clips
Tip Protector
E
D
Fig. 10
F
F
E
M U L T I - S T I M U L U S D E T E C T O R T E S T E R
testifire
®
E
E
www.
testifire
.com
Back to Contents Page
Fig. 11
Fig. 13
Fig. 12
English
Deutsch
Español
Français
Preparing for use
Please wait
Fig. 15
Fig. 14
English
Select Cancel
System Info.
Language
Sounder
System Reset
CO Capsule Removal Instructions
(Testifire 2000 series only)
Only replace the CO capsule when it is empty. Testifire should be
turned off for five minutes to allow the ‘CO’ capsule to cool down
before removing it.
Release the lower access cover
(Fig. 9) on the body of the Testifire
D
unit by opening it from the right hand side.
Squeeze the spring clips
(Fig. 9)on each side and gently pull the
E
capsule out.
Do not touch the tip of the CO capsule as it may be hot.
CO Capsule Replacement Instructions
Remove the capsule from its outer carton and anti-static bag.
Remove the tip protector from the tip of the capsule (Fig. 10).
F
Holding the capsule by the spring clips (Fig. 10) with the label
E
uppermost, carefully insert the new capsule into the capsule
port. Push it into position, ensuring that the spring clips spring
out positively on both sides of the capsule
and engage with the
port properly. Close the CO
access cover
(Fig. 9) securely.
D
