Fig. 5
Fig. 6
CAUTION
Ensure correct orientation when inserting Battery Baton into tool and do not use undue
force to insert.
Remove Battery Baton from Testifire when not in use.
page 8
M U L T I - S T I M U L U S D E T E C T O R T E S T E R
testifire
®
www.
testifire
.com
Back to Contents Page
CAUTION
Store charger in a dry place (indoor use only when connected to AC mains). Danger of fire
and electric shock! Do not fast-charge a hot battery, allow the Battery Baton to cool down
naturally before starting a charge cycle. Allow the charger to cool down for at least 15
minutes after one fast charge. Stop charging if the Battery Baton becomes too hot during
charging (>55-60°C). Do not leave unattended whilst charging. Only clean with a dry cloth.
Do not attempt to open the charger. Repair permitted only by authorised dealer.
Battery Batons must be stored and charged in accordance with stated environmental
conditions.
Environment: Operating temperature:5
°C to 45°C / 40°F to 115°F
Storage temperature: -
10°C to 50°C / 15°F to 120°F
Humidity:0
-90% RH non-condensing
ATTENTION
This charger is designed for charging fast rechargeable NiMH Battery Batons (Solo 760) only. Do not connect
other types of batteries. Danger of explosion.
ENVIRONMENT
Battery Batons must be disposed of at a recognised recycling centre. Local authorities can provide advice on the
best method.
4.2
Using the Battery
To insert the Battery Baton into Testifire, hold the Testifire head unit by the
handle and depress
the upper
spring button on the Battery Baton. Align the
button with the location hole in the handle and push the Battery Baton into the
handle until the button springs up through the location hole (Fig. 5).
: Slight rotation of the Battery Baton may assist alignment when inserting.
TIP
Insert the other end of the Battery Baton into the Solo access pole and depress
the lower spring button. Align it with the location hole and push the Battery
Baton further into
the pole until the button springs up through the hole (Fig. 6).
