Dentsply Sirona Multimat Cube, Instruction Manual

Page: 28 / 40

28
4.6 Firing and pressing programs
The following is an illustrative example of how to execute a firing program or pressing programs
(Multimat® Cube press only).
4.6.1 Overview of firing and pressing parameters
Starting temperature
Specifies the temperature at which the firing/pressing program starts.
Pre-drying time Specifies the time during which the starting temperature will be held with the firing
chamber open.
Closing time
Specifies the time during which the firing chamber will close gradually; the starting
temperature will he held.
Pre-heating time Specifies the time during which the starting temperature will be held with the firing
chamber closed.
Vakuum Specifies the vacuum level in the firing chamber.
Firing stages Specifies the number (max. 3) of stages (holding levels) used.
Heating rate
Specifies the speed of the temperature rise.
End temperature End temperature reached during the firing/pressing program.
Vacuum time Specifies the time during which the vacuum will be maintained after the end tem-
perature is reached.
Holding time Specifies the time during which the final temperature will be held.
Tempering temperature Specifies the tempering temperature to be reached.
Tempering time Specifies the time during which the tempering temperature will be held.
Cooling Specifies the time during which the firing chamber will slowly open
Pressdruck
Specifies the pressure exerted on the pressing plunger.
Pressing time Specifies the time during which the pressing ie performed.