31
4.7
Special programs
The <Firing>
<Predefined>
<Special programs> menu contains the following special programs:
<Silver wire test>
Calibration program for correcting temperature deviations,
Section 6.2 “Calibrating the unit”.
<Dehydration
For dehydrating (removing moisture from) the firing chamber insulation after
with pump>
prolonged non-use.
<Pre-heating>
For preheating and drying the firing chamber insulation to the parameters specified
in the pre-heating program,
Section 4.8 “Smart pre-heating program”.
<Cleaning program>
For cleaning the firing chamber, including the firing tray and pins.
4.8
Smart pre-heating program
The pre-heating program is used for pre-heating and drying the firing chamber insulation to the parameters
specified in the pre-heating program.
Executing the pre-heating program manually:
Touch <Settings>
<Furnace>
<Start pre-heating program>
or
Touch <Firing>
<Predefined>
<Special programs>
<Pre-heating>
Activating smart pre-heating:
Touch <Settings>
<Furnace>
<Pre-heating> and turn to “ON”.
• The next time the unit is turned on, you will be prompted to run the pre-heating program.
• If the pre-heating program was run completely and without aborting and the unit was subsequently turned
off, the next prompt to run the pre-heating program will be shown after 10 hours.
• If the pre-heating program is not run or if it is aborted, the prompt to execute the pre-heating program will
return each time the unit is turned on.
4.9 Power failure behaviour
In the event of a power failure while a program is running, an error message will appear once the power
has returned.
The Multimat® Cube/Multimat® Cube press is equipped with a safety feature in the event of a power failure,
so that the current program will be continued if there is sufficient vacuum and sufficient heat left.
If the vacuum or temperature drop thresholds are exceeded, an error message will appear and the program
will be aborted.
4.10 Muffle fracture (Multimat® Cube press only)
The Multimat® Cube press is equipped with a muffle fracture detection feature.
If the pressing plunger does not register any resistance during the execution of a pressing program,
a fracture may have occurred in the pressing ring; an error message will appear in this case.
Summary of Contents for Multimat Cube
Page 1: ...Instruction Manual Multimat Cube Multimat Cube press...
Page 39: ...39...
