Delta RetroSign GRX-1, User Manual

Page: 62 / 80

RetroSign GRX User Manual / December 2017
62
DELTA
contact your dealer.
Error Unable to save calibration. Internal filesystem problem. Try restarting GRX.
If problem persists,
contact your dealer.
Error Offset too High/Low on channel: channel
name
Calibration target is not as
expected or hardware
problem. Check calibration
target for damage.
Clean lenses.
If problem persists,
contact your dealer.
Error Target value too High/Low on channel:
channel name
The entered calibration
values are not valid. Scan the QR code
from the calibration
block.
Error Dark raw value too High/Low on channel:
channel name
Dark calibration raw values
are not as expected. Redo the calibration
following the procedure
described.
If problem persists,
contact your dealer.
Error Signal raw value too High/Low on
channel:
channel name
Calibration raw values are
not as expected. Check calibration
target for damage.
Clean lenses.
If problem persists,
contact your dealer.
Error Dark/Signal raw value too High/Low on
channel:
Reference Dark/Target
Hardware problem on
reference channel. If problem persists,
contact your dealer.
Error LED current too High/Low Hardware problem with
LED light source. If problem persists,
contact your dealer.
Measurement
Type Text Cause How to resolve
Warning There is no GNSS fix yet. The GNSS receiver has not
received a fix. Move outside or wait
for it to get a fix.
Warning Angle adapter not mounted. Angle adapter not detected. Attach angle adapter.
Warning RA value too High/Low on channel:
channel name
The measured value is too
extreme. Recalibrate the
instrument.
Warning Raw value too High/Low on channel:
channel name
Raw sensor readings are
out of specifications.
Hardware problems. If problem persists,
contact your dealer.
Log export
Type Text Cause How to resolve
Warning USB drive not ready. USB drive cannot be found. Plug in USB memory
stick. Make sure it is
FAT formatted and wait
at least 10 seconds
from inserting until
pressing
Export .
Error USB power. Unable to activate power to
USB port. Most likely a
hardware problem. If problem persists,
contact your dealer.