Dell PowerEdge T710, Hardware Owner'S Manual

Page: 37 / 214

About Your System
37
I1911 LCD Log Full.
Check SEL to
review all
Errors.
LCD overflow message. A
maximum of ten error
messages can display
sequentially on the LCD.
The eleventh message
instructs the user to check
the SEL for details on the
events. Check the SEL for details
on the events.
Remove AC power to the
system for 10 seconds or
clear the SEL.
I1912 SEL full.
Review & clear
log.
The SEL is full of events
and is unable to log any
more. Check the SEL for details
on the events, then clear
the SEL.
I1920 iDRAC6 Upgrade
Successful
iDRAC6 Express card has
been installed correctly Information only
W1228 RAID
Controller
battery
capacity <
24hr.
Warns predictively that
the RAID battery has less
than 24 hours of charge
left. Allow RAID battery to
charge to greater than 24
hours of sustained charge.
If problem persists,
replace RAID battery. See
"Installing a RAID
Battery" on page 128.
W1627 Power required
> PSU wattage.
Check PSU and
config.
The system configuration
requires more power than
what the power supply can
provide. Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
W1628 Performance
degraded.
Check PSU and
system
configuration.
The system configuration
requires more power than
what the power supply can
provide, but it can boot if
throttled. Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
"Glossary" on page 195.
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 37 Monday, June 15, 2009 11:33 AM