Dell PowerConnect 7024, Manual

Page: 905 / 1234

Configuring IP Routing
905
Configuring PowerConnect Switch A
To configure Switch A.
1 Enable routing on the switch.
console# configure
console(config)#
ip routing
2 Assign an IP address to VLAN 10. This command also enables IP routing
on the VLAN.
console(config)# interface vlan 10
console(config-if-vlan10)# ip address 192.168.10.10
255.255.255.0
console(config-if-vlan10)# exit
3
Assign an IP address to VLAN 20.
console# configure
console(config)# interface vlan 20
console(config-if-vlan20)# ip address 192.168.20.20
255.255.255.0
console(config-if-vlan20)# exit
4 Assign an IP address to VLAN 50.
console# configure
console(config)#
interface vlan 50
console(config-if-vlan50)# ip address 192.168.50.50
255.255.255.0
console(config-if-vlan50)# exit
5
Configure a static route to the network that VLAN 30 is in, using the IP
address of the VLAN 20 interface on Switch B as the next hop address.
console(config)# ip route 192.168.30.0
255.255.255.0 192.168.20.25
6 Configure the backbone router interface as the default gateway.
console(config)# ip route default 192.168.50.2