Broadcom Teaming Services: Broadcom NetXtreme II Network Adapter User Guide
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/teamsvcs.htm[9/26/2012 3:29:14 PM]
Teaming with Microsoft NLB
Teaming with Microsoft Virtual Server 2005
The only supported BASP team configuration when using Microsoft Virtual Server 2005 is with a Smart Load Balancing (TM)
team-type consisting of a single primary Broadcom adapter and a standby Broadcom adapter. Make sure to unbind or
deselect "Virtual Machine Network Services" from each team member prior to creating a team and prior to creating Virtual
networks with Microsoft Virtual Server. Additionally, a virtual network should be created in this software and subsequently
bound to the virtual adapter created by a team. Directly binding a Guest operating system to a team virtual adapter may not
render the desired results.
NOTE: As of this writing, Windows Server 2008 is not a supported operating system for Microsoft Virtual Server 2005;
thus, teaming may not function as expected with this combination.
Teaming Across Switches
SLB teaming can be configured across switches. The switches, however, must be connected together. Generic Trunking and
Link Aggregation do not work across switches because each of these implementations requires that all physical adapters in a
team share the same Ethernet MAC address. It is important to note that SLB can only detect the loss of link between the
ports in the team and their immediate link partner. SLB has no way of reacting to other hardware failures in the switches and
cannot detect loss of link on other ports.
Switch-Link Fault Tolerance
The diagrams below describe the operation of an SLB team in a switch fault tolerant configuration. We show the mapping of
the ping request and ping replies in an SLB team with two active members. All servers (Blue, Gray and Red) have a
continuous ping to each other.
Figure 3
is a setup without the interconnect cable in place between the two switches.
Figure 4
has the interconnect cable in place, and
Figure 5
is an example of a failover event with the Interconnect cable in place. These
scenarios describe the behavior of teaming across the two switches and the importance of the interconnect link.
The diagrams show the secondary team member sending the ICMP echo requests (yellow arrows) while the primary team
member receives the respective ICMP echo replies (blue arrows). This illustrates a key characteristic of the teaming software.
The load balancing algorithms do not synchronize how frames are load balanced when sent or received. In other words,
frames for a given conversation can go out and be received on different interfaces in the team. This is true for all types of
teaming supported by Broadcom. Therefore, an interconnect link must be provided between the switches that connect to ports
in the same team.
In the configuration without the interconnect, an ICMP Request from Blue to Gray goes out port 82:83 destined for Gray port
5E:CA, but the Top Switch has no way to send it there because it cannot go along the 5E:C9 port on Gray. A similar scenario
occurs when Gray attempts to ping Blue. An ICMP Request goes out on 5E:C9 destined for Blue 82:82, but cannot get there.
Top Switch does not have an entry for 82:82 in its CAM table because there is no interconnect between the two switches.
Pings, however, flow between Red and Blue and between Red and Gray.
Furthermore, a failover event would cause additional loss of connectivity. Consider a cable disconnect on the Top Switch port
4. In this case, Gray would send the ICMP Request to Red 49:C9, but because the Bottom switch has no entry for 49:C9 in its
CAM Table, the frame is flooded to all its ports but cannot find a way to get to 49:C9.
Figure 3: Teaming Across Switches Without an Interswitch Link
