Dell 5210n Mono Laser Printer, Service Manual

Page: 147 / 430

Diagnostic information
2-105
Paper from Tray x does not reach the pass thru sensor
Service tip: Check the media in tray
x
to make sure it is within specifications. Some types of labels, foil material,
and slick papers can cause misfeeds and slippage of the rollers.
Interconnect card service check
Warning:
When replacing any one of the following components:
•
Operator panel assembly (or upper front cover)
•
System board assembly
•
Interconnect card assembly
Only replace one component at a time. Replace the required component and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one or the printer will be
rendered inoperable.
Warning:
Never install and remove components listed above as a method of troubleshooting components.
Once a component has been installed in a printer, it can not be used in another printer. It must be
returned to the manufacturer.
FRU Action
1
Autocompensator
assembly
Check the autocompensator pick arm rollers for any sign of glazing,
toner or other buildup. Clean or replace as necessary.