Dell 5210n Mono Laser Printer, Service Manual

Page: 145 / 430

Diagnostic information
2-103
271.xx
Paper Jam - Check Bin x
, POST incomplete
Input sensor service check
Service tip: Run the Base Sensor Test. Check the input sensor for proper operation. The display changes from
open to closed as the sensor flag is manually moved in and out of the sensor.
Input tray(s) service check
Optional 250-sheet and 500-sheet trays
Service tip: Try all the other input paper sources to make sure they are properly feeding paper.
For 990 Error Code- Service Tray
x
,
x
= displays the number of the tray that has a problem or needs service.
FRU Action
1
Upper pass thru sensor flag
assembly
Upper control board
Check the flag for correct operation, binding, broken parts, or
interference from the sensor cable. If incorrect, repair as necessary.
If correct, make sure the lower pass thru sensor is correctly
connected to J3 on the lower control board. Disconnect the pass thru
sensor cable and check the voltage at J3-3. The voltage measures
approxi5 V dc. If incorrect, check the voltage at J3-2. The
voltage measures approximately 0 V dc. If incorrect, replace the
sensor assembly. If this does not fix the problem, replace the high-
capacity output stacker option.
FRU Action
1
Input sensor flag Check the input sensor flag for damage and proper operation. If a
problem is found, repair as necessary.
2
System board Check for approxi5 V dc at J15-10 on the system board. If
incorrect, replace the system board.
3
Input sensor cable Check the continuity of the input sensor cable section of the front
wiring harness. If incorrect, replace the harness. If correct, replace
the input sensor assembly.
FRU Action
1
Tray
x
Option system board
or compensator assembly
or autoconnect cable
Check the autoconnect cables and connectors for damage. If the
cables, connectors, and connections are good, replace the FRUs in
the following order:
• Autocompensator assembly option
• Replace the option.