78
xxx
|
OBWI Operation
xxx
Avocent User Account Settings
NOTE:
User account settings are supported when the Dell RAK is installed.
You can contact and register an unmanaged switch with an Avocent
management software device by specifying the IP address of the management
software device.
To configure the device IP address:
1
On the side navigation bar, select
User Accounts - Avocent
. The Avocent
Management Software Settings screen is displayed.
2
Enter the device IP addresses that you want to contact. Up to four
addresses are allowed.
3
Use the scroll bar to select the desired retry interval.
4
To disassociate the SCS that has been registered with the device, click the
Disassociate
button.
5
Click
Save
.
Override Admin
NOTE:
Override Admin is supported when the Dell RAK is installed.
To be prepared in case a network failure should occur, configure the Override
Admin Account before any other settings.
To configure the Override Admin Account in the OBWI:
1
Click
User Accounts
, then click
Override Admin
.
2
Type the username and password you wish to assign to the user and then
verify the password by typing it in the Verify Password field.
3
Click
Save
.
Summary of Contents for 1081AD
