OBWI Operation
xxx
|
xxx
73
To change the SIP Auto-Upgrade feature:
1
From the side navigation bar, click
Ports - SIPs
to open the SIPs screen.
2
Select the checkboxes next to the SIPs that you wish to upgrade and click
Enable Auto-Upgrade
.
Attention:
Disconnecting a SIP during a firmware update or cycling power to
the device will render the module inoperable and require the SIP to be returned
to the factory for repair.
To upgrade the SIP firmware:
1
From the side navigation bar, click
Ports - SIPs
to open the SIPs screen.
2
Select the checkboxes next to the SIPs that you wish to modify.
3
Select
Choose an operation
and select
Upgrade
.
4
If the settings are correct, click
Upgrade
.
To set the USB Speed:
NOTE:
This section only applies to the USB2 SIP.
1
From the side navigation bar, click
Ports - SIPs
to open the SIPs screen.
2
Select the checkboxes next to the SIPs that you wish to modify.
Launching a Session
NOTE:
Java 1.6.0_11 or later is required to launch a session.
To launch a session:
1
From the side navigation bar, select
Target Devices
. A list of available
devices will appear.
2
The applicable action, KVM Session, will be displayed in the Action
column, and will depend on the target device that was selected to launch
the session. If more than one action is available for a given target device,
click the drop-down arrow and select the applicable action from the list.
Summary of Contents for 1081AD
