Identifier
GUID-848CD34D-A60B-46DE-A999-33BF688287FE
Status
Released
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the
processor and heat sink module
Steps
1
Place the heat sink with the processor side facing up.
2
Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 53. Loosening the processor bracket
4
Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
5
Flex the outer edges of the bracket to release the bracket from the processor.
NOTE:
Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
108
Installing and removing system components
