3
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4
If applicable, disconnect the power or data cables from expansion card(s).
Steps
1
Locate the battery socket. For more information, see the
System board jumpers and connectors
section.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or removing a
battery.
2
Use a plastic scribe to pry out the system battery.
Figure 96. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 97. Installing the system battery
Next steps
1
Installing the expansion card riser 1
.
2
If applicable, connect the cables to the expansion card(s).
3
If applicable, open the PCIe card holder latch on the air shroud to secure the full length expansion card.
4
Follow the procedure listed in
After working inside your system
.
5
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
6
Enter the correct time and date in the System Setup
Time
and
Date
fields.
7
Exit the System Setup.
Identifier
GUID-109C6962-A67D-4618-99C9-1B6169E19CA6
Status
Released
Power supply units
The power supply unit (PSU) is an internal hardware component which supplies power to the components in the system.
Your system supports 1100 W and 750 W AC power supply units (PSUs).
144
Installing and removing system components
