User Manual UX11
2
Press the
ENTER/START
button until you see
100%
,
50%
or
30%
blinking.
3
Press the
DEC/INC
buttons to select the desired charge state.
4
Press and hold the
ENTER/START
button to start the process.
7.2.4
Cycle mode
In this mode you can recondition a battery by putting it through multiple charge-discharge cycles.
By cycling the batteries, the individual cell voltages are balanced.
1
Press the
PROG/MODE
button until you see a screen similar to the one below:
2
Press the
ENTER/START
button until you see UX11 blinking.
3
Press the
ENTER/START
button until the number next to
C->D
starts flashing.
4
Use the
DEC/INC
buttons to select the desired number of cycles.
5
Press and hold the
ENTER/START
button to start the process.
RESULTS
The cycle process will always start and end with a charge.
For example, when selecting 3 cycles, the sequence will be:
Charge
-
Discharge
-
Charge
-
Discharge
-
Charge
-
Discharge
-
Charge
When setting the safety timer to 65 min, the total maximum time spent for completing the 3 cycles
will be 7 × 65 min = 455 min.
7.2.5
Checking battery parameters while charging
During charging/discharging or cycling you can check the battery’s parameters.
1
Press and hold the
DEC
and
INC
buttons simultaneously.
2
Use the
INC
or
DEC
button to cycle through the parameters
RESULTS
The most important parameter is the individual cell voltages (see below).
You can also view the maximum unbalancing difference (last screen).
Delair
|
676, Rue Max Planck – 31670 Toulouse-Labège, France
|
Tel: +33 (0) 5 82 95 44 06
| www.delair.aero
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair and cannot be used or reproduced without the written authorization of Delair.
41