DEHACO B.V.
Kruisbaak 25, 2165 AJ Lisserbroek (NL)
Tel.:+31(0)88 20 20 600
www.dehaco.nl
Dehaco Tera 45, 60, 75, 90. Model year 2016 -
12
of
31
- File:User Manual_Tera 400V Dust Control Unit_UVC6000_v3.0_EN.docx
Implement anti-swivel/movement features.
9. Use
9.1 Set-up
TAKE NOTE!!
First rinse the water hose before it is
connected!
This helps to prevent dust or debris,
which was already in the hose, from
polluting and/or blocking the spraying
unit!!
TAKE NOTE!! IMPORTANT!!
Water pressure in the supply pipe must
be maximum 6 bar!!
Possibly check this using a manometer!!
1.
Determine the most suitable location for
setting up the TERA: As close as possible to the
product that must be sprayed, but far enough
to operate without being hindered! When
doing so, consider: the power cable (do not
always drive over it!!), water supply, wind
direction, spraying distance and swivel range.
2.
Place the Dust Control Unit on a smooth,
hardened and reasonably horizontal surface.
3.
For a trailer-based TERA: Activate the brake on
the trailer and uncouple it. Lower both
support pillars at the rear, so the trailer
remains stable and does not bounce.
4.
Rinse the water hose, clean the coupling and
connect it to the water supply.
5.
Check the power cable for damage (first repair
damage!!) and then connect the power cable.
6.
The frequency regulator will now start; the
touchscreen will also start up if applicable.
7.
Release both movement blocks to activate the
swivel function (photo)!!
8.
Make sure the emergency stop button is not
activated.
9.
Reset the water meter if required.
