Connect the anode as follows:
+ Connection on the calorifier tank
- Connection on the anode
Caution
If the calorifier tank does not have a TAS anode, connect the
simulation anode (= accessory)
5.8.5
Connecting the power cable
The power connection is located in the rear part of the control box. The
power connection is fitted with a 10AT fuse.
Danger of electric shock
Always turn off the main power before working on the electrical
connections.
Make sure the following requirements are met when connecting the power
cable:
Tab.43 Power connection
Wire cross section
Stripping length
Tightening torque
solid wire: 2.5 mm² (AWG 14)
stranded wire: 2.5 mm² (AWG 14)
stranded wire with ferrule: 2.5 mm² (AWG 14)
7 mm
0.5 N⋅m
1. Undo the quarter turn screw.
2. Remove the cover.
3. Connect the power cable to the connector block.
4. Close the cover.
5. Tighten the quarter turn screw.
Fig.59
Anode connector
AD-4000005-02
+ TA -
TA
Fig.60
Connecting the power cable
AD-3001593-01
L
N
1
2
3
5 Installation
7762666 - v.02 - 29092020
C 340 / C 640
53
