Datapath Q Series, Instructions For Use Manual, Page: 69 / 104

Q-Series Change Transceivers
69
Change Transceivers
Introduction
The Q-Series can be mounted with an X-, Ku-, or Ka-band transceiver. The procedure to
switch transceivers is simple, and can be done by the operator.
Change Transceiver
Prerequisites
Turn off the Q-Series and disconnect from the power source.
Tools and Materials
Torx T20
Procedure
1. Push down the polarization knob and turn the LNB counterclockwise until it is in its horizontal
position. (Only for Ku-band transceivers).
2. Disengage the Rx cable from the cable holder on the transceiver. (Only for X- and Ku-band
transceivers).
3. Disconnect the Rx cable by pulling on the connector housing.
4. Disconnect the Tx cable by pulling on the connection housing.
5. Disconnect the Power/M&C cable by turning the connector housing counterclockwise.
6. Lift the feed arm until the screws can be reached. Do not lift the feed arm too high since that
poses the risk of the transceiver falling out.