SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide
77
Cleaning the Internal Components
Dirt
introduced
during
card
feed
or
burrs
caused
by
friction
between
the
bobbin
holder
and
bobbin
can
adhere
to
the
card
or
film,
causing
card
lamination
defects.
Clean
these
components
regularly
to
avoid
lamination
defects.
1.
Power
off
the
laminator.
2.
Open
the
laminator
door.
3.
Press
and
hold
down
the
cartridge
release
button
and
pull
out
the
top
laminate
film
cartridge
(LM200
only)
and
the
bottom
laminate
film
cartridge.
4.
Use
a
Datacard®
printhead
cleaning
swab
(provided
in
the
Cleaning
Kit.
Refer
to
“Cleaning
Supplies”
on
page 109
)
to
clean
the
following
components:
a.
Bobbin
holders:
two
for
each
film
cartridge
b.
Rear
guide
rails,
on
each
side
of
the
heat
roller.
Clean
upper
and
lower
surfaces.
c.
Front
guide
rails,
on
each
side
of
the
heat
roller.
Clean
upper
and
lower
surfaces.
5.
Remove
any
slack
in
the
cartridges.
6.
Reinstall
both
the
top
and
bottom
film
cartridges
in
the
laminator.
7.
Close
the
laminator
door.
