SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide
45
If
the
printer
cannot
recognize
the
type
of
ink
ribbon,
one
of
the
following
reasons
is
displayed:
Use
the
Media
Setting
tab
to
view
or
change
the
type
and
thickness
of
cards
being
used:
1.
For
Material
,
select
PVC
,
PET
‐
G
,
or
HR
‐
PET
‐
G
(0.25
mm).
The
recommended
values
for
retransfer
speed
and
temperature
depend
on
the
selected
card
type.
(Refer
to
“Retransfer
Tab”
on
page 43
.)
2.
For
Thickness
,
select:
Standard
for
cards
0.75
mm
(0.030
inch)
thick
Thin
for
cards
0.25
mm
(0.010
inch)
thick
3.
Use
Film
Type
to
select
the
type
of
retransfer
film
being
used.
Tips
for
Success
sample
cards
to
verify
settings
before
using
cards
of
a
different
thickness
or
material
type.
on
one
side
of
thin
cards.
Do
not
on
both
sides.
Set
the
input
hopper
for
the
card
thickness.
Refer
to
“Adjusting
Card
Thickness”
on
page 14
.
Thin
PVC
cards
are
not
supported.
Display
Reasons
for
ink
recognition
error
Solutions
252:
Invalid
TAG
Data
The
data
for
the
ink
ribbon
is
incorrect.
Replace
the
ink
ribbon
and
try
again.
253:
Defective
TAG
The
printer
did
not
recognize
the
ribbon
data.
Replace
the
ink
ribbon
and
try
again.
254:
No
TAG
The
printer
could
not
read
the
ribbon
data.
Make
sure
that
the
ink
ribbon
has
been
loaded
correctly.
Refer
to
“Loading
an
Ink
Ribbon”
on
page 15
.
255:
Defective
R/W
The
printer
is
defective.
The
printer
must
be
repaired.
Caution:
The Thin setting is not recommended for
use with PVC cards.
