Danfoss VLT CDS 803, Programming Manual

Page: 89 / 92

Literature.................................................................................................... 4
Load sharing............................................................................................. 3
Local Control Panel (LCP)..................................................................... 8
Logic rule................................................................................................. 49
Logic rule boolean 2............................................................................ 50
Logic rule boolean 3............................................................................ 51
Logic rule operator 2........................................................................... 51
M
Main menu.............................................................................................. 16
Mains
on/off.................................................................................................... 54
Max output frequency........................................................................ 26
Maximum inter-char delay................................................................ 41
Maximum reference............................................................................. 23
Maximum response delay................................................................. 41
Menu key.................................................................................................... 8
Menus.......................................................................................................... 9
Minimum reference............................................................................. 23
Motor
status.................................................................................................... 59
Motor set-up............................................................................................. 9
Motor speed high limit....................................................................... 26
Motor speed low limit......................................................................... 26
Motor Thermal Protection................................................................. 22
N
Navigation key......................................................................................... 8
NPN............................................................................................................ 27
O
Open loop............................................................................................... 22
Operating data...................................................................................... 57
Operating hours.................................................................................... 57
Operation key........................................................................................... 8
Overmodulation................................................................................... 54
P
Parameter lists....................................................................................... 75
Parity/Stop bits...................................................................................... 41
PNP............................................................................................................ 27
Preset ref bit 0........................................................................................ 28
Preset ref bit 1........................................................................................ 28
Preset ref bit 2........................................................................................ 28
Preset relative reference..................................................................... 24
Program, how to...................................................................................... 8
Programming
Programming....................................................................................... 8
with MCT 10 Set-up Software........................................................ 8
Protocol.................................................................................................... 41
Pulse input.............................................................................................. 35
Q
Quick menu............................................................................................... 9
Quick menu, closed loop set-up........................................................ 9
Quick menu, open loop applications............................................... 9
Quick stop ramp time......................................................................... 25
Quick transfer, parameter settings (multiple frequency con-
verters)...... 17
R
Ramp 1 Ramp down time.................................................................. 25
Ramp 1 Ramp up time........................................................................ 25
Ramp 2 Ramp up time........................................................................ 25
Rated compressor speed...................................................................... 5
RCD............................................................................................................... 5
Readout/programming, indexed parameter.............................. 17
Recommended initialisation............................................................ 17
Relay.......................................................................................................... 32
Relay output [bin]................................................................................. 62
Reset mode............................................................................................. 55
Reversing................................................................................................. 28
Run permissive...................................................................................... 28
Running hours....................................................................................... 57
S
Safety........................................................................................................... 4
Serial communication......................................................................... 32
Serial communication port.................................................................. 5
SL controller action.............................................................................. 52
SLC setting.............................................................................................. 45
Smart logic.............................................................................................. 45
Smart logic controller event............................................................. 52
Special functions.................................................................................. 54
Speed bypass......................................................................................... 27
Speed down........................................................................................... 28
Speed up.................................................................................................. 28
Start........................................................................................................... 28
Start delay............................................................................................... 22
Start event............................................................................................... 45
Start reversing....................................................................................... 28
Status menu.............................................................................................. 9
Status word............................................................................................. 59
Index Programming Guide
MG18P202 Danfoss A/S © 06/2019 All rights reserved. 87