Illustration 3.3 Cable Holders
1.
Remove the LCP from the FC 302.
2.
Remove the frame below the LCP.
3.
Push the option into place. 2 positions are
possible, with cable terminal facing either up or
down. The cable up position is often most
suitable when several frequency converters are
installed side-by-side in a rack, as this position
permits shorter cable lengths.
4.
Push the fieldbus option adaptor frame for the FC
302 into place.
5.
Remount the LCP.
6.
Attach the cable.
7.
Fasten the cable using cable holders.
3.2.2 Adapter Plate
To ease the replacement of VLT 5000 with VLT
®
AutomationDrive, there is a number of adapter plates available. The adapter
plates have the same footprints as VLT 5000 and have threaded holes for VLT
®
AutomationDrive. The adapter plate prevents
damage that can occur from drilling new threaded holes in the backboard of the enclosure. The adapter plate also
decreases the time required to exchange a broken frequency converter.
The following mechanical adapter plates are available:
Ordering
number
Style
Height [mm]
Width [mm]
Type
130B0183
Bookstyle, IP20
395
90
5001-5003 200-240 V
5001-5005 380-500 V
130B0184
Bookstyle, IP20
395
130
5004-5006 200-240 V
5006-5011 380-500 V
130B0185
Compact, IP20
395
220
5001-5003 200-240 V
5001-5005 380-500 V
5004-5006 200-240 V
5006-5011 380-500 V
5001-5011 550-600 V
Table 3.2 Ordering Numbers for Adapter Plates
Installation
Operating Instructions
MG37E102
Danfoss A/S © Rev. 2014-03-06 All rights reserved.
9
3
3
