Danfoss FC 300 Series, Programming Manual

Page: 16 / 216

2.1.6 Parameter Set-up
The adjustable frequency drive can be used for practically all
assignments, which is why the number of parameters is quite
large. The adjustable frequency drive offers a choice
between two programming modes - a Main Menu and a
Quick Menu mode.
The former provides access to all parameters. The latter takes
the user through a few parameters, making it possible to
start operating the adjustable frequency drive.
Regardless of the mode of programming, you can change a
parameter both in the main menu and quick menu modes.
2.1.7 Quick Menu Key Functions
Pressing [Quick Menus] The list indicates the different areas
contained in the Quick menu.
Select
My Personal Menu to display the chosen personal
parameters. These parameters are selected in 0-25 My
Personal Menu . Up to 20 different parameters can be added
in this menu.
Select Quick set-up to go through a limited amount of
parameters to get the motor running almost optimally. The
default setting for the other parameters considers the
desired control functions and the configuration of signal
inputs/outputs (control terminals).
Parameters are selected by using the arrow keys. The
parameters in the following table are accessible.
Parameter Setting
0-01 Language
1-20 Motor Power [kW] [kW]
1-22 Motor Voltage [V]
1-23 Motor Frequency [Hz]
1-24 Motor Current [A]
1-25 Motor Nominal Speed [rpm]
5-12 Terminal 27 Digital Input [0] No function*
1-29 Automatic Motor
Adaptation (AMA)
[1] Enable complete AMA
3-02 Minimum Reference [rpm]
3-03 Maximum Reference [rpm]
3-41 Ramp 1 Ramp-up Time [sec]
3-42 Ramp 1 Ramp-down Time [sec]
3-13 Reference Site
* If terminal 27 is set to “no function”, no connection to +24
V on terminal 27 is necessary.
Select Changes made to get information about:
•
the last 10 changes. Use the [
▲
] [
▼
] navigation keys
to scroll between the last 10 changed parameters.
•
the changes made since default setting.
Select Loggings to get information about the display line
readouts. The information is shown as graphs.
Only display parameters selected in
0-20 Display Line 1.1
Small and 0-24 Display Line 3 Large can be viewed. It is
possible to store up to 120 samples in the memory for later
reference.
How to Program FC 300 Programming Guide
2-6 MG.33.MA.22 - VLT
®
is a registered Danfoss trademark
2 2