The information below describes how to assemble screened power cables to the electric device.
P itsch BlueGlobe-series cable glands and H+S Radox Elastomer S automotive cables are
recommended. Cable gland assembly instruction can also be found from P itsch gland catalogue
available from
Cable lug and cable gland assembly steps
1. Remove the small hexagonal piece from the BlueGlobe-sealing insert as shown in Figure below.
Figure 10. BlueGlobe-sealing
2. Cut the cable sheath at the distance A from the end of the cable, see Figure below. Pull the cut
part of the sheath partly (length B is from 10 to 15 mm) off the cable as shown in the gure.
Distance A depends of the lenght of the used cable lug. Measure with the cable lug that is used
and cut to suitable lenght.
Do not remove the cable sheath completely at this point and do not cut the braid screen of the cable.
Figure 11. Cut lenght of the cable sheath
3. Insert the cable to the cable gland with slight turning motion. This helps the cable go through
the spring inside the cable gland. Push the cable gland against the sheath of the cable as shown in
Figure below.
EC-LTS1200-410
5. Installation
| BC355449988603en-000101
©
Danfoss | Produced By: Danfoss Power Solutions | September 2020 | 29