XSL rigging modes - 2 in 1
Pin [3]
Compression mode:
In Compression mode, the splay angle between the
cabinets (e.g. 2° as shown in the graphic opposite) is
set on the rear rigging strand of the upper cabinet
using pin
[3].
Tension mode:
In Tension mode, pin
[3] is always inserted in the
0° hole at the bottom of the inner hole grid to fix the
Splay link in place (
Þ
Red labeled hole -
).
Pin [3]
Compression frame:
In Compression mode the compression frame is
attached below the last cabinet of the array. In this
case, pin
[3] is also always inserted in the 0° hole
of the inner hole grid (
Þ
Red labeled hole -
).
First cabinet to frame
Due to the length of the frame's Splay link, for both, Compression
and Tension modes, the Splay link of the frame is
always
engaged in the
0° hole at the top of the center hole grid of the
first cabinet using pin
[1] and safety pin [2] (
Þ
Red labeled holes
-
).
Pin [3] convention
Compression | Tension mode
d&b XSL Rigging manual 1.1 en
- preliminary -
7
