Compression mode setup
11. Securing the lever hoist
WARNING!
Potential risk of personal injury and/or
damage to material.
The second chain leg of the Compression frame master link is
intended as a secondary safety device to secure (bridge) the
Crank lever hoist in the event that its primary suspension or its
breaking system should fail.
▪ Therefore the grab link of the chain leg has to be attached to
the
compression chain and NOT to the load chain of the
hoist.
▪ Ensure the grab link is properly attached as shown in the
graphic below.
12. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the checklist given
Chapter 7 "Safety and system checks" on page 38.
d&b XSL Rigging manual 1.1 en
- preliminary -
33
