Tension mode setup
4. Attaching the next assembly
Due to the weight of the cabinets, further assemblies cannot be
attached out of the cart in one go. The Splay links have to be
engaged manually cabinet by cabinet. Proceed as follows:
1. Lift the first assembly to allow the next assembly to be
positioned below.
2. Position the next assembly and extend the Front links of the
uppermost cabinet.
3. Lower the array until the Front links of the top cabinet in the
cart fit into the slots at the front of the bottom cabinet of the
array.
4. Insert and lock the second Locking pins of the cabinet's Front
links on both sides.
5. At the rear, insert Locking pin
[1] into the desired splay angle
hole (e.g. 8°).
6. On the cabinet below, release the Splay link (Locking pin
[1]
and
[2]).
7. Lift the back of the first cabinet of the assembly until the Splay
link has engaged.
8. Reinsert Locking pin
[2] (Safety pin).
9. For the remaining cabinets, proceed in the same manner.
d&b XSL Rigging manual 1.1 en
- preliminary -
36
