Compression mode setup
2. Attaching the compression chain
1. Release the Locking pin of the coupling shackle.
2. Attach the coupling shackle to the dedicated hole position at
the rear end of the load beam.
3. Reinsert the Locking pin and ensure the pin is fully inserted and
locked.
3. Attaching the crank lever hoist
At a certain point during setup, the grab link (shortening link) of the
lever hoist has to be attached to the compression chain. Its position
depends on the length and the final curvature of the array and is
calculated and indicated in ArrayCalc («Sources» view
Þ
«Grab link position»).
1. Attach the grab link, as shown in the graphic opposite.
2. Ensure the grab link is properly attached.
4. Preset the splay angles
On the inner and center hole indices, preset the splay angles (e.g.
2°) according to your ArrayCalc project using Locking pin
[3]
(See also
Chapter 2 "XSL rigging modes - 2 in 1" on page 6 ).
d&b XSL Rigging manual 1.1 en
- preliminary -
29
