Compression mode setup
5. On the rear rigging strand, release Locking pin
[2] and check
Locking pin
[1] is set to 0° (
Þ
Red labeled holes -
).
6. Pull the Splay link of the upper cabinet out of its temporary
park position.
7. Slightly lower the array and fold the Splay link into the rigging
strand.
8. Slightly lift the array until the Splay link has engaged into the
preset Locking pin
[1].
9. Insert and lock Locking pin
[2] (Safety pin) to secure the Splay
link in place.
10. Lift the entire array approx. 30 cm (1 ft) above ground and
dismantle the Touring cart as described previously.
11. Preset the splay angles as described previously.
For the attachment of further touring cart assemblies, proceed in
the same manner.
7. Attaching the compression frame
1. Lift the entire array to a suitable working height.
2. With one person on each side, release the Locking pins at the
front of the compression frame.
3. Insert the front studs into the corresponding slots at the front of
the cabinet.
4. Reinsert the Locking pins on both sides.
5. At the center rear, release the bottom Locking pin of the
compression frame's Splay link slot.
6. Pull the Splay link out of its temporary park position.
7. Raise the frame until the Splay link has engaged into the
Locking pin.
8. Reinsert the bottom Locking pin (Safety pin) to secure the
Splay link in place.
d&b XSL Rigging manual 1.1 en
- preliminary -
31
