Compression mode setup
5. Dismantling the touring cart
1. Lift the entire assembly to a height of approx. 30 cm (1 ft)
above ground.
2. At the center rear Splay link slot, release the bottom Locking
pin.
3. Slightly lift the cart and disengage the Splay link.
4. Reinsert the Locking pin and lower the cart.
5. With one person on each side, release the Locking pins at the
front of the cart.
6. Lower the cart, reinsert the Locking pins into their park
positions and put the cart aside.
6. Attaching the next assembly
1. Lift the first assembly to allow the next assembly to be
positioned below.
2. Position the next assembly and extend the Front links of the
uppermost cabinet.
3. Lower the array until the Front links of the top cabinet in the
cart fit into the slots at the front of the bottom cabinet of the
array.
4. Insert and lock the second Locking pins of the cabinet's Front
links on both sides.
d&b XSL Rigging manual 1.1 en
- preliminary -
30
