Compression mode setup
8. Attaching the compression frame master link
1. Attach the hook to the shackle of the compression frame.
2. Attach the O-ring of the master link to the hook on the housing
of the lever hoist.
9. Adjusting the lever hoist
To adjust the lever hoist, proceed as follows:
Þ
Set the lever mode selector
[3.4] to the neutral position
(
Þ
).
↳In this mode, the load chain can be freely pulled through
the hoist to its required length.
10. Curving the array
Before curving the array, recheck the actual status of the entire
assembly according to the checklist given in
and system checks" on page 38.
To curve the array, proceed as follows:
1. Set the lever mode selector
[3.4] to the lifting position (
Þ
).
2. Turn the free chain knob
[3.1] clockwise until the hoist has
engaged to its load chain.
3. Fold out the crank
[3.3].
4. Operate the lever
[3.2] clockwise until the array is completely
curved.
↳The maximum permitted compression force has been
achieved when the lever kinks.
5. Stop further operation and set the lever mode selector
[3.4]
back to the neutral position (
Þ
) and fold the crank
[3.3]
back into place.
d&b XSL Rigging manual 1.1 en
- preliminary -
32
