Z-Trak2 3D Profiler Sensors
Z-Trak2 2K Series overview
•
5
Key features
•
Real-time, factory-calibrated outputs measurements in real-world units (micrometers,
millimeters, and thousands of an inch)
•
The Z-Trak2 S-Series delivers profile rates up to 45 KHz using 5 GigE interface
•
The Z-Trak2 V-Series delivers profile rates up to 10 KHz using 1 GigE interface
•
Available in red (660 nm) and blue (405 nm) lasers with safety class 2M or 3R (both eye-safe)
•
Variety of models cover field of view from 13 mm to 1210 mm and Z range from 4 mm to
650 mm
•
Built-in, single-scan high dynamic range (HDR) capabilities, handles high and low reflective
surfaces at the same time
•
Multi-sensor combination and synchronization in different topologies for 360° measurements or
for occlusion elimination
•
Supports quadrature shaft-encoder input for external profile triggers
•
External scan start/stop triggers for fixed and variable length scans
•
GigE Vision 2.0, GeniCam 3.0 and SFNC 2.3 compliant
•
Supports Windows and Linux platforms
•
Free bundled software packages:
Sherlock™ 8 (rapid applicatio
n deployment), Sapera LT SDK
8.61 (scan and control), Sapera Processing 8.0 runtimes (1D, 2D and 3D image processing),
•
Z-Expert 2.0 features intuitive graphical interface for rapid setup of multiple Z-Trak2 sensors
simultaneously
•
Enhanced 3D visualization of profile and surface view from one more sensors simultaneously
•
Third-party software support for 3D image processing using
GenICam™
3.0 3D output formats
or 16-bit monochrome output format
•
Compact, integrated within a ruggedized protective housing (IP67) with tapped and through
mounting holes
Refer to the Z-Trak2 features reference and Technical specifications sections of the manual for full
details.
About GigE Vision and GenICam
Z-Trak2 3D laser profiler sensors are 100% compliant with the GigE Vision
®
2.0 specification, which defines the communication interface protocol used by
any GigE Vision device. The device description and capabilities are contained
in an XML file. For more information see: https://www.automate.org/a3-
content/vision-standards-gige-vision
Z-Trak2 3D laser profiler sensors implement a superset of the GenIC
am™
specification that defines device capabilities. This description takes the form
of an XML device description file respecting the syntax defined by the GenApi
module of the GenICam specification. For more information see
The GigE Vision-compliant XML device description file is embedded within Z-Trak2 firmware,
allowing GigE Vision-compliant applications access to Z-Trak2 capabilities and controls immediately
after connection.
