DALBO MAXICUT 920, Manual, Page: 33 / 49

MAXICUT
Page 33
Adjustments
Wheels
The wheel bearing must be lubricated and adjusted once a year. Also make sure you have the
correct tyre pressure (see tyres).
Adjustments and lubrication of wheel bearings
1.
Hub cap is removed.
2. The cotter is removed.
3. The castellated nut is tightened with a 1/6 turn, so that the hole is aligned with the shaft.
The wheel is spun around and there should be no resistance. Only a little bit of slack
should be felt in the hub housing when the wheel is moved from side to side. If there is
too much slack, repeat the process.
4. The cotter is installed.
5. The hub cap is filled ¾ with grease and fitted.
Swivel stool
The swivel stools must be checked for wear at regular intervals. If they are not clamped to-
gether, tighten them to prevent unnecessary wear and tear on the machine.
Fig. 20
1. The cotter pin is knocked out.
2. The crown nut (A) is tightened until
the plates are firmly against each
other.
3. The cotter pin is installed again and
the swivel stools are lubricated until
grease comes out along the edge.

It is important for the swivel stools to be clamped together. Otherwise damage,
breakdown or inappropriate wear and tear could occur on the frames and swivel
stools.
A