DALBO MAXICUT 920, Manual, Page: 31 / 49

MAXICUT
Page 31
Maintenance
Good maintenance ensures a long life for the MAXICUT and therefore optimal use of the ma-
chine. Grease fittings have therefore been installed in places where wear is greatest.

All screw connections must be tightened after the first day of work. Cotter pins and
bolts should be checked to avoid breakdowns. The hydraulic system should also be
checked to ensure it is air-tight.
Lubrication
It is important that the machine is lubricated at the specified intervals to prevent unneces-
sary wear on moving parts.
In the lubrication table, when it is written, for example, 3 x 2 means that there are 3 lubrica-
tion tubes on each side of the machine. Thus, 6 lubrication points at this location.
The lubrication points are specified on the following page.
Fig. 18
Lubrication points Num-
ber of
nuts
Lubrica-
tion in-
terval
hours
Images
Pull - Hydraulics 10 8 A.1
Pull - Lift feature 2 8 A.2
Timing belt with cylinders 3 X 2 8 B
Swivel stool top and bottom 10 X 2 8 C
Mobile frame sides 3 X 2 8 D
Mobile frame centre 5 8 E
Bearings 1 X 6 50 F
Break covers 3 X 2 8 G
Wheel bearings 2 200 H
Wave plate section side (Extra equipment) 7 X 2 8 I
Wave plate section centre (Extra equipment) 6 8 J

All lubrication points should be greased at least once a year.
A.1 A.2 C
B
E
D
F
G H